Font of rage + Unforgiving passive

Using totem + font of rage, the rage decay start immediatly after leaving area of the font of rage (3m) even using the passive nod "unforgiving" (Rage loss starts 1 sec later), but I still have the +4 maximum rage.

Font of Rage breaks rage.

Rage says right on it that it goes away after 2 seconds if you haven't gained rage recently.

Font overrides that and makes it so that if you leave the 3m radius of the object giving the font it starts dropping immediately.

Basically making font of rage useless unless you put up your stationary object every 1.5 meters that you move. The support doesn't have an area tag and doesn't seem to scale with the size of the skill that it supports.

I tried it with totems and to keep up the rage I basically had to clear maps 10x slower than I would otherwise. I cant see a good use case for it except maybe a boss where you set it up before hand and wait 15 seconds to get full then go start boss. Still not worth it though probably as you have to dodge boss mechs and you aren't going to stop and move your font around in front of you as you evade.

+1 very sad

Pathed all the way over to this passive thinking that it would make Font of Rage more viable for my totem build. Neither the 1 second loss delay nor the loss rate decrease work properly. Nothing in the Font of Rage description indicates that it doesn't work with rage delay & loss rate passives.

Sad :(
Font of Rage should work with the 2 second delay, or state in the support that overwrites the delay